Electricity Forum Intelligent Power Today Magazine Arc Flash Clothing

Fall Protection


Choosing Your Rubber Safety Gloves

Latex versus Natural Rubber – What is the difference? All Raw rubber comes from the rubber tree. It is then processed to become a latex for water-based dipping or dried down to a slab for use in extrusion or solvent dipping operations. Hydrophilic additives in Latex For latex to be usable...

Ugh, Why So Much HSE Paper?

With the advent of our modern health, safety and environmental systems (HSE), the requirement to produce more documents is relentless. No one feels this pressure more than our front line supervision; those individuals, who are leading our crews out in the field. Not only are they tasked with...

How to Prevent Struck-By and Backover Incidents

Struck-by, struck-against and back-over incidents are far too common: 421 Hudson St., Manhattan, NYC: Construction worker killed by scaffolding plank. Woods Hole Golf Club, Falmouth, MA: Construction worker injured in back-over accident. Interstate 440-East, Raleigh, NC: DOT workers seriously...

Fall Protection

fall protection testing

Testing Conditions and Guidelines for Personal Fall Protection Systems

1. PERSONAL FALL ARREST SYSTEMS

(A) GENERAL TEST CONDITIONS

Lifelines, lanyards, and deceleration devices should be attached to an anchorage and connected to the body-belt or body harness in the same manner as they would be when used to protect employees, except that lanyards should be tested only when connected directly to the anchorage, and not when connected to a lifeline.
The anchorage should be rigid, and should not have a deflection greater than .04...

Related Articles


workers safety

How to Prevent Struck-By and Backover Incidents

Struck-by, struck-against and back-over incidents are far too common: 421 Hudson St., Manhattan, NYC: Construction worker killed by scaffolding plank. Woods Hole Golf Club, Falmouth, MA: Construction worker injured in back-over accident. Interstate 440-East, Raleigh, NC: DOT workers seriously...

Utility workers safety technology

The Right Vendor Partnerships Positively Impact Line Crew Safety

A variety of factors influence the safety of those who work on utility lines. Many of the items are standard and likely on everyone’s line worker safety checklist. But there’s one that may not be top-of-mind when considering how to keep linemen and linewomen safe — the influence...

wildfire on electric pole

Lineman Safety during a Wildfire

If you wanted to create a recipe for disaster, the beginning of the 2021 wildfire season would be a good place to start. Nearly 90% of the western U.S. is suffering through extreme drought. The snowpack set new low levels there as well. A record-breaking heatwave steamrolled the Pacific Northwest...

Electric Utility System Standards

How Ontario regulation can improve electrical safety BY BILL KHASHFE, London Hydro According to an Ontario Electrical Safety Report, 35 percent of the province’s electrical-related fatalities in the past 10 years were attributed to power-line contact. Equipment specifications and electric utility...


fall protection safety

Fall Protection: The ABCs of Connecting Devices

A personal fall protection arrest system (PFAS) is comprised of three vital components: an anchorage, body wear (full-body harnesses), and a connecting device (a shock-absorbing lanyard or self-retracting lifeline). The safety of at-height workers depends on these three components, and each one...

wildfire on electric pole

Lineman Safety during a Wildfire

If you wanted to create a recipe for disaster, the beginning of the 2021 wildfire season would be a good place to start. Nearly 90% of the western U.S. is suffering through extreme drought. The snowpack set new low levels there as well. A record-breaking heatwave steamrolled the Pacific Northwest...

Linemen safety PPE

Hand Safety - Protective Gloves

Rubber insulating gloves are among the most important articles of personal protection for electrical workers. To be effective, the gloves must incorporate high dielectric and physical strength, along with flexibility and durability. For superior performance they should meet and/or exceed the...

fall protection testing

Testing Conditions and Guidelines for Personal Fall Protection Systems

1. PERSONAL FALL ARREST SYSTEMS (A) GENERAL TEST CONDITIONS Lifelines, lanyards, and deceleration devices should be attached to an anchorage and connected to the body-belt or body harness in the same manner as they would be when used to protect employees, except that lanyards should be tested only...

personal fall protection arrest system

Fall Protection: The ABCs of Connecting Devices

A personal fall protection arrest system (PFAS) is comprised of three vital components: an anchorage, body wear (full-body harnesses), and a connecting device (a shock-absorbing lanyard or self-retracting lifeline). The safety of at-height workers depends on these three components, and each one...

Remote deployed field crews safety

ENHANCING REMOTE WORKER SAFETY

Remote field operations present the safety organization with a myriad of challenges when it comes to ensuring the safety of the people that you send out to work in the field every day. Without a doubt, this includes the line workers, but it also includes nearly every member of the staff whose...

Page 1 of 4