Electricity Forum Intelligent Power Today Magazine Arc Flash Clothing
Electrical Substations Featured Fleet Management Growth & Innovation HV Test Equipment Industry News & Trends Lineman Safety MARKETPLACE Overhead T&D Power Transformers Renewable Energy Smart Grid Smart Metering Software and Apps State of Industry T&D Automation T&D Companies T&D Products White Papers

Fall Protection


Choosing Your Rubber Safety Gloves

Latex versus Natural Rubber – What is the difference? All Raw rubber comes from the rubber tree. It is then processed to become a latex for water-based dipping or dried down to a slab for use in extrusion or solvent dipping operations. Hydrophilic additives in Latex For latex to be usable...

Safety Reports for Utility Workers

Protecting utility workers with documented reporting BY MIKE DOHERTY, PowerTel Utilities Contractors Limited Within the lineman trade, accountabilities for the documentation of various inspections, job safety analyses (JSAs), audits, safe work practices (SPGs), qualifications, safety meetings,...

Ugh, Why So Much HSE Paper?

With the advent of our modern health, safety and environmental systems (HSE), the requirement to produce more documents is relentless. No one feels this pressure more than our front line supervision; those individuals, who are leading our crews out in the field. Not only are they tasked with...

Fall Protection

personal fall protection arrest system

Fall Protection: The ABCs of Connecting Devices

A personal fall protection arrest system (PFAS) is comprised of three vital components: an anchorage, body wear (full-body harnesses), and a connecting device (a shock-absorbing lanyard or self-retracting lifeline). The safety of at-height workers depends on these three components, and each one must be in place and used properly to provide maximum worker protection.
When discussing fall protection, anchorage connectors and full body harnesses receive a lot of attention. We don’t always stop to think...

Related Articles


paper documntation

Ugh, Why So Much HSE Paper?

With the advent of our modern health, safety and environmental systems (HSE), the requirement to produce more documents is relentless. No one feels this pressure more than our front line supervision; those individuals, who are leading our crews out in the field. Not only are they tasked with...

Electrical Hazard Protection

How to reduce dangers while providing preventive maintenance data BY FINLEY LEDBETTER, Group CBS, Inc. While most discussions about avoiding electrical hazards focus on personal protective equipment (PPE), utility workers have a number of ways to protect themselves and their gear, including...

workers safety

How to Prevent Struck-By and Backover Incidents

Struck-by, struck-against and back-over incidents are far too common: 421 Hudson St., Manhattan, NYC: Construction worker killed by scaffolding plank. Woods Hole Golf Club, Falmouth, MA: Construction worker injured in back-over accident. Interstate 440-East, Raleigh, NC: DOT workers seriously...


fall protection safety

Fall Protection: The ABCs of Connecting Devices

A personal fall protection arrest system (PFAS) is comprised of three vital components: an anchorage, body wear (full-body harnesses), and a connecting device (a shock-absorbing lanyard or self-retracting lifeline). The safety of at-height workers depends on these three components, and each one...

wildfire on electric pole

Lineman Safety during a Wildfire

If you wanted to create a recipe for disaster, the beginning of the 2021 wildfire season would be a good place to start. Nearly 90% of the western U.S. is suffering through extreme drought. The snowpack set new low levels there as well. A record-breaking heatwave steamrolled the Pacific Northwest...

Linemen safety PPE

Hand Safety - Protective Gloves

Rubber insulating gloves are among the most important articles of personal protection for electrical workers. To be effective, the gloves must incorporate high dielectric and physical strength, along with flexibility and durability. For superior performance they should meet and/or exceed the...

fall protection testing

Testing Conditions and Guidelines for Personal Fall Protection Systems

1. PERSONAL FALL ARREST SYSTEMS (A) GENERAL TEST CONDITIONS Lifelines, lanyards, and deceleration devices should be attached to an anchorage and connected to the body-belt or body harness in the same manner as they would be when used to protect employees, except that lanyards should be tested only...

personal fall protection arrest system

Fall Protection: The ABCs of Connecting Devices

A personal fall protection arrest system (PFAS) is comprised of three vital components: an anchorage, body wear (full-body harnesses), and a connecting device (a shock-absorbing lanyard or self-retracting lifeline). The safety of at-height workers depends on these three components, and each one...

Remote deployed field crews safety

ENHANCING REMOTE WORKER SAFETY

Remote field operations present the safety organization with a myriad of challenges when it comes to ensuring the safety of the people that you send out to work in the field every day. Without a doubt, this includes the line workers, but it also includes nearly every member of the staff whose...

Page 1 of 4